PT100 Temperature Sensor

PT100 Temperature Sensor

15.00
Quantity:
Only 2 left in stock
Add To Cart

PT100's are high temperature, high accuracy temperature sensors that you can now use on your E3D V6 HotEnd instead of a thermistor or thermocouple. PT100's are able to measure higher temperatures than thermistors - upto 400°C, and are more accurate then both thermistors and thermocouples in general. Our PT100 sensors are also very easy to handle, being of a metal cartridge type construction that is secured with a set screw, no more fiberglass sleeving or clamping washer.

The PT100 sensor will not fit in the standard E3D Hotends, but can be used with E3D V6, Chimera, Lite6, and Kraken by using the PT100 Heater Block available in the spares and extras section.

Please be aware that a PT100 is not the same as a thermistor and unless your electronics explicitly supports RTD Sensing devices you will need an amplifier board.

Resources

Documentation

E3D PT 100 Amplifier Documentation